Thomas & Betts TY526M Cable Tie 11" 30lb Natural Nylon Stainless Steel Lock 100 Pack
- 100PC 11 in NATL TY…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Pack of ten 150 mm 4-pin RGB extension cables with male and female connectors for 3528 and 5050 SMD LED strips
This pack supplies ten 150 mm 4-pin cables with male and female ends for extending RGB LED strips. Each cable bridges strip-to-strip or strip-to-controller gaps in 3528 and 5050 SMD installations. The connectors suit both non-waterproof and waterproof strip variants.
At 5.9 inch each cable covers short runs inside cases, behind monitors or along cabinet edges. Longer continuous spans will need additional jumpers because the fixed 150 mm length cannot be joined without extra connectors. Sharp 90-degree bends are possible but repeated flexing at the solder point may fatigue the PVC jacket.
The PVC insulation resists incidental moisture and protects the four conductors during routing through tight channels. Male and female plugs press-fit securely yet release when pulled, so strips stay connected during vibration but can be rearranged without tools. Buyers needing IP-rated seals or in-wall rated cable should look elsewhere.
Measured against everything we stock in Wire, Cable & Wiring Supplies, at today’s prices. Recalculated every night.
No published specifications for this item yet.
Yes, the 4-pin male and female plugs are made for standard 3528 and 5050 SMD RGB strips, so they will connect directly to your existing tape.
Power the strip and cycle through red, green, blue and white on your controller; if each colour appears cleanly across the joint, the 4-pin link is working.
No extra parts are required; the connectors press onto the strip’s copper pads, though a soldering iron and heat-shrink can be used for a more permanent joint if desired.
More in Wire, Cable & Wiring Supplies
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?