A-Tech 8GB DDR3 1600 ECC UDIMM CL11 1.50V 2Rx8 Server Memory

8GB DDR3 1600 ECC UDIMM Server Module

This 8GB DDR3 1600 ECC UDIMM module is built for servers and workstations that require error-correcting memory. It operates at PC3-12800 speed with CL11 latency and standard 1.50V voltage. The unbuffered design suits platforms that accept ECC UDIMMs rather than registered DIMMs. It is sold as a single 2Rx8 stick using major brand chips.

240-Pin DIMM Build and Daily Handling

The module uses the standard 240-pin DDR3 DIMM form factor, so it installs in any compatible UDIMM slot keyed for DDR3. Gold edge contacts resist oxidation during repeated seating, and the green PCB provides rigid support inside crowded chassis. No heatsink is present, allowing tight side-by-side population in dense server boards. The 2Rx8 organisation is reported by the SPD for automatic timing configuration.

Compatibility Checks Before Ordering

Verify that your system board accepts DDR3 ECC UDIMMs at 1600MHz and does not require registered or load-reduced modules. Confirm the maximum supported capacity per slot and total population limit in the vendor documentation. Cross-reference the HP part numbers 669239-081, 669239-581, 669324-B21, 669324-B212, 684035-001, and 815371-B21 to ensure this module matches your qualified vendor list.