Crucial CP16G60C36U5B 16GB DDR5 6000 desktop RAM
- 16 GB
- DDR5 6000
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
8GB DDR4 2133MHz CL15 desktop DIMM module at 1.2V for HP T0E51AT compatibility
This A-Tech module supplies 8GB of DDR4 memory at 2133MHz with CL15 latency and 1.20V operation. The unbuffered 288-pin DIMM uses major-brand chips and is validated as a direct replacement for HP part T0E51AT. It targets desktop owners who need a straightforward capacity increase for everyday workloads.
The kit fits standard consumer desktops that accept non-ECC unbuffered DDR4 DIMMs and is described as compatible with both AMD and Intel platforms. Systems requiring ECC, registered, or load-reduced modules cannot use this stick, nor can laptops or small-form-factor boards that need SO-DIMMs. Buyers should confirm their motherboard supports 2133MHz DDR4 before ordering.
The CAS latency of 15 cycles at the standard 1.20V DDR4 voltage is the key timing figure that determines whether this module matches the memory controller requirements of a given platform. If a system demands tighter timings or a different voltage, this part will not be optimal.
Measured against everything we stock in Desktop RAM, at today’s prices. Recalculated every night.
New to this? Buying memory and SSDs with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | A-Tech |
| Total capacity | 8 GB |
| Performance | |
| Rated speed | DDR4 2133 (PC4 17000) |
| Processor | |
| Chipset | Major Brand Chips |
| Memory | |
| CAS latency | CL15 |
| Tested speed | 2133 |
| ECC support | No |
| Buffer type | Unbuffered |
| Power | |
| Rated voltage | 1.2 V |
| Compatibility | |
| Recommended for | AMD & Intel Compatible |
The 1Rx8 DDR4 DIMM has no firmware and no moving parts, so it does not require updates or component swaps once installed.
The CL15 timing at 2133 MHz sets the latency floor, and the JEDEC 1.2 V voltage caps maximum data rate under continuous load.
At the standard 1.2 V DDR4 voltage the module draws minimal power and generates low heat, keeping noise at zero since it has no fan.
More in Desktop RAM
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?