ALPHASONIK ALPHA 1K 1000W Class D Mono Car Amplifier
A Class D mono amplifier delivering 500W RMS at 2 ohms and 1000W at 1 ohm with variable crossover, bass EQ and remote bass control
- Amplifier classClass D
- Amplifier channelsMono
- Maximum power1000 W
- RMS power rating500 W
- Product typeAmplifiers
- Class D efficiency delivers 1000 W peak power
- 500 W RMS at 2 ohms drives subwoofers hard
- Variable low-pass 50 Hz–20 kHz tunes bass precisely
- Bass boost 0–12 dB adds low-end punch
- Compact 185 × 58.5 × 145 mm fits tight spaces
Alpha 1K Class D Mono Amplifier
The Alpha 1K is a Class D monoblock car amplifier rated at 1000 W maximum power and 500 W RMS. It delivers 350 W at 4 ohms, 500 W at 2 ohms and 1000 W at 1 ohm in a compact chassis measuring 7.28 x 2.30 x 5.71 inches.
For Bass Systems Needing High Power at Low Impedance
This amplifier suits installations that run a single subwoofer at 1 or 2 ohms and want 500 to 1000 W RMS from a small footprint. Buyers who need stereo output, multi-channel surround or full-range component amplification should look at a different topology.
Straightforward Install With Built-In Protection
The mono design means only one speaker channel and one set of RCA inputs to connect, while nickel-plated terminal blocks accept power and ground cables cleanly. A remote bass knob is included for level control. The 4-way protection circuit guards against thermal, short-circuit, overload and DC-offset faults, reducing the risk of damage from wiring mistakes.
How it compares
Measured against everything we stock in Car Audio Amplifiers, at today’s prices. Recalculated every night.
- Price $147.99
- Cheaper than about 67% of the 158 comparable items (median $225.49).
Specifications
| Product | |
|---|---|
| Product type | Amplifiers |
| Audio & video | |
| Amplifier channels | Mono |
| RMS power rating | 500 W |
| Power | |
| Maximum power | 1000 W |
| More details | |
| Amplifier class | Class D |
Questions about this item
What impedance subwoofer do I need so the amp can deliver its 500 W RMS rating?
Wire a single 2-ohm subwoofer to the mono output; the specs list 500 W x 1 @ 2 ohms as the RMS figure.
If I keep my factory head unit, will the 200 mV – 6 V input sensitivity range accept its speaker-level outputs?
Yes, the variable input sensitivity adjusts from 200 mV up to 6 V, covering typical factory speaker-level signals without a line-output converter.
After installation, how can I verify the protection circuitry is active and the amp is not in fault mode?
Power the system and confirm the amp stays on without shutting down; the 4-way protection (thermal, short-circuit, overload, DC offset) engages automatically if a fault occurs.
More in Car Audio Amplifiers
Similar items
Wet Sounds WS-NMEA-TR NMEA 2000 Audio Controller Remote
- Amplifier & Process…
Wet Sounds Front Battery 4 Amplifier Power Kit car amplifier
- Amplifiers
METRA AXDIS-CL2 GM Data Interface SWC 2000-2013 car amplifier
- Signal Processors





