Amcrest ASH21 Dinosaur Silicone Camera Cover (Green)
Silicone dinosaur skin protects Amcrest ASH21 cameras from scratches and dust while adding a playful nursery look
- Product typeAccessory
- Adorable dinosaur design disguises your nursery camera
- Soft silicone skin shields ASH21 from scratches and dust
- Tailored fit for Amcrest ASH21-W and ASH21-B indoor cameras
- Lightweight cover adds protection without blocking the lens
- Green dinosaur theme blends into a child's room décor
Nursery camera disguise
This green dinosaur silicone cover slips over the Amcrest SmartHome Indoor Camera ASH21-W and ASH21-B. It turns the security device into a playful nursery accent while keeping the lens and sensors exposed. The skin is shaped specifically for the ASH21 body so it stays in place during normal use.
Replaces a bare camera finish
The cover takes the place of the camera’s original plastic shell, adding a soft barrier against scratches, dust and fingerprints. The jump is worth it when the camera sits in a child’s room or high-traffic area where bumps and smudges are frequent. It does not change any camera function or mounting method.
Tool-free slip-on fit
Installation is a matter of stretching the flexible silicone over the camera body until it seats evenly. What usually goes wrong is forcing the cover on upside down, which can block the microphone or status light. A quick visual check of the lens cut-out prevents that issue.
How it compares
Measured against everything we stock in Camera Extras & Accessory Packs, at today’s prices. Recalculated every night.
- Price $6.99
- Cheaper than about 93% of the 2,266 comparable items (median $39.99).
Specifications
| Product | |
|---|---|
| Product type | Accessory |
Questions about this item
Will this dinosaur silicone cover fit my Amcrest ASH21-W indoor camera?
Yes, this cover is designed specifically for the Amcrest SmartHome Indoor Camera ASH21-W and ASH21-B models.
How do I install the silicone skin on the camera without blocking the lens?
Stretch the flexible silicone over the camera body, aligning the openings with the lens and sensors before pressing it into place.
How should I clean the silicone cover if it gets dusty or smudged?
Remove the cover and wash it with mild soap and water, then dry thoroughly before putting it back on the camera.
More in Camera Extras & Accessory Packs
Similar items
Weinandianzi WN-3640DM V21 3MP OV3640 CMOS Camera Module 2048x1536 70° 24PIN DVP
- 13 × 9 × 9 cm
- Camera Module 2048…





