Aomoproing USB 3.1 Type-C Dual M2 Screws Locking to Locking USB-C 10Gbps Data Cable Panel Mount Type 1.2m
A 1.2 m USB 3.1 Type-C cable with dual M2.0 screw-locking connectors for secure 10 Gbps data links in panel-mount installations
Cable Length 4 Feet
- 4 Feet$9.99
- 6.6 Feet$10.99
- 10 Feet$13.99
- Secure screw-locking connectors prevent accidental disconnection
- Dual M2.0 panel-mount screws ensure a firm industrial-grade fit
- Reversible USB-C plugs insert either way up for quick installation
- USB 3.1 Gen 2 delivers 10 Gbps data throughput
- 2 m length suits panel-mount and rack setups
Locking USB-C 10 Gbps cable
This USB 3.1 Type-C cable carries data at 10 Gbps over a 1.2 m run. Dual M2.0 screw-locking connectors on both ends prevent accidental disconnection in industrial or rack environments. The reversible Type-C plugs simplify insertion without checking orientation.
Panel-mount build and screw retention
M2.0 panel-mount screws let the connector be secured to a chassis or bulkhead for a fixed, vibration-resistant link. Locking screws on each plug mate with threaded receptacles so the cable stays seated during movement or shock. The design targets equipment that cannot tolerate a loose connection.
10 Gbps practical ceiling
The USB 3.1 interface tops out at 10 Gbps, so throughput cannot exceed that limit even with faster host controllers. Cable length is fixed at 1.2 m; longer runs would require an active extender not covered here. Builders needing higher bandwidth or longer reach must look beyond this specification.
How it compares
Measured against everything we stock in USB Cords & Extension Cables, at today’s prices. Recalculated every night.
- Price $9.99
- Cheaper than about 88% of the 15,227 comparable items (median $14.99).
Specifications
No published specifications for this item yet.
Other versions of this model
2 more in the same range
Questions about this item
What practical throughput does the USB 3.1 Gen 2 interface cap at?
The cable supports up to 10 Gbps data transfer under the USB 3.1 specification.
What panel cut-out and hardware does the M2.0 locking screw require?
Each end uses an M2.0 panel-mount screw; drill a matching M2 thread hole in the chassis to secure the connector.
How do you install the dual-screw locking connectors without cross-threading?
Align both M2.0 screws by hand, turn each a few threads alternately, then tighten evenly with a small hex driver — forcing one side first strips the threads.
More in USB Cords & Extension Cables
Similar items
Tripp Lite U322-006 USB 3.0 A Male to B Male cable 6 ft
- USB A to USB B
- Consumer Electronics
STARTECH UUSBHAUB6LA USB 2.0 A to Left Angle Micro USB B Cable
- USB A to Micro USB
- USB 2.0
ESTONE Essager XC100W USB-C cable 100W 480Mbps blue 6.6ft
- USB Type-C
- USB-C Cable
STARTECH USB3SEXT1M USB 3.0 extension cable 3.28 ft
- USB A to USB A
- Data Transfer Cable







