Appliance Factory Parts 62601019 Thermistor Sensor Kit for Friedrich EL24N35B SS14N10C-C YS10N10C-A SS12N30C-A

Genuine Friedrich Thermistor Sensor Kit

This kit provides an original Friedrich thermistor sensor bearing part number 62601019. It is built for Friedrich room air conditioners carrying the model codes EL24N35B, SS14N10C-C, YS10N10C-A and SS12N30C-A. The component monitors coil temperature to protect the sealed system and maintain correct cooling cycles. It is not a universal substitute and will not fit units outside the listed model range.

Direct replacement for factory temperature probe

The sensor plugs into the existing control harness inside the indoor section, requiring no wiring modifications or refrigerant recovery. Installation restores the factory temperature feedback loop so the compressor and fan operate on accurate data. Technicians should verify the model tag before ordering because the same chassis series uses different sensors across the 10, 12, 14, 24 and 30 capacity classes.

Replaces a failed or drifted OEM thermistor

A sensor that reads high or low causes short-cycling, icing or loss of cooling, and this kit returns the system to specification. The jump is worthwhile when diagnostics confirm an open, shorted or out-of-calibration probe rather than a control-board fault. Units not listed — including other Friedrich series or competing brands — are not compatible with this part number.