Axiom DDR4 16 GB DIMM 288-Pin 2400 MHz CL17 1.2 V Unbuffered Non-ECC

16 GB DDR4 DIMM for system memory upgrades

This 16 GB DDR4 module adds main memory capacity to compatible desktops and workstations. It uses a standard 288-pin DIMM form factor and runs at 2400 MHz with CL17 latency. The unbuffered, non-ECC design suits typical consumer and office platforms.

Simple slot insertion

Installation consists of aligning the notch and pressing the module into the DDR4 slot until the retention clips engage. No drivers or configuration software are required. The most common issue is a mismatch between the module speed or voltage and the motherboard specification, so verify that the board supports 2400 MHz operation at 1.2 V before fitting.

Suits users expanding standard desktop memory

This stick suits anyone adding 16 GB to a system that accepts unbuffered non-ECC DDR4 at 2400 MHz. It will not meet the needs of servers or workstations requiring registered or ECC modules, nor boards limited to lower speeds or different pin counts. Buyers needing higher frequencies, lower latencies or larger single-module capacities should look elsewhere.