PYLE AUDIO PP444 Phono Turntable Pre Amplifier 12 V DC car electronics accessory
- Installation Tools
- Converts Phono Sign…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A 12 V DC rocker switch rated at 20 A with a red illuminated actuator for panel mounting
This Battery Doctor 20532 is a single-pole single-throw rocker switch rated at 20 amps and 12 volts DC. It fits a standard 12mm by 30mm panel cutout and uses 1/4-inch male terminals for wiring. The red illuminated actuator shows the on state at a glance. It is intended for automotive and low-voltage DC accessory circuits.
The switch body is rated to carry 20 amps continuously at 12 volts DC with minimal voltage drop across the contacts. No active cooling is required and the device operates silently because it contains no moving parts beyond the rocker mechanism. Heat generation stays low in typical accessory loads such as lighting or small motors.
The built-in red LED lights only when the switch is in the on position, giving immediate visual confirmation without a separate indicator lamp. The panel-mount design with a 12mm by 30mm footprint allows clean installation in dashboards or custom enclosures. Three terminals simplify wiring for power, load and illumination ground.
Measured against everything we stock in Car Audio Accessories & Wiring, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Brand name | Battery Doctor |
| Model name | 20532 |
| Product type | DC Adapters |
| Size & build | |
| Shipping weight | 0.04 kg |
| Package size | 25 × 25 × 25 mm |
Push the switch body through the rectangular cut-out until the housing flanges seat flush, then tighten the 1/4 inch male terminals onto the 20 A @ 12V DC circuit; the step most people skip is verifying the SPST on/off orientation before securing the panel.
The red illuminated actuator and SPST contacts are rated for 20 A at 12V DC; inspect the 1/4 inch terminals for corrosion or loosening after extended vibration and replace the entire unit if the light dims or the on/off action becomes intermittent.
The 20 A @ 12V DC current rating is the primary limit; sustained loads at or above this level will cause contact heating and actuator temperature rise before any voltage or mechanical endurance limit is reached.
More in Car Audio Accessories & Wiring
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?