APC APCRBC158 UPS Replacement Battery for BX1000M
- Battery
- APCRBC158, APC
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
12 V sealed lead-acid replacement battery compatible with Back-UPS NS Network 40, BN4001 and BE450G units
This 12 V DC sealed lead-acid battery replaces the APCRBC114-SLA114 unit in APC Back-UPS NS Network 40, BN4001 and BE450G models. It restores runtime for desktop workstations, home-office networking gear and small server closets that rely on those specific UPS units. The direct-fit design matches the original form factor so no wiring changes are needed.
The battery arrives pre-charged and ready to install; simply open the UPS battery door, disconnect the old pack and connect the new one using the existing terminals. Polarity is keyed to prevent reverse connection, but verify the red and black leads match before seating the pack. A common issue is forgetting to recycle the spent battery — local regulations usually require drop-off at a hazardous-waste point.
Confirm the UPS model number on the rear label matches BN4001, BE450G or Back-UPS NS Network 40 before ordering. Ensure the replacement slot accepts the standard APCRBC114-SLA114 footprint, as some revised chassis use a different cartridge. Buyers needing extended runtime beyond the original capacity or a lithium chemistry alternative should look elsewhere.
Measured against everything we stock in UPS Replacement Batteries, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Battery Technology Inc. |
| Product type | Battery |
After fitting the replacement unit, power on the UPS and verify the front-panel status shows normal operation with no battery-fault indicator; then run a self-test from the UPS control panel or management software to confirm the 12 V DC pack holds voltage under load.
The package contains the sealed 12 V DC lead-acid battery cartridge only; mounting hardware, connection cables and any UPS firmware updates are not included and must be sourced separately if required.
The APCRBC114-SLA114 is listed as compatible with Back-UPS NS Network 40, BN4001 and BE450G models; match the exact UPS model number on your unit to one of those three designations before ordering.
More in UPS Replacement Batteries
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?