IPCW LEDT-344CB Tail Lamps LED Bermuda Black 2000-2005
- 2005 Chevy Monte Ca…
- Performance
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Pack of ten red 12 V LED marker lights with strobe, high and low modes and IP67 rating
A pack of ten 4-inch red side marker units combines a strobe warning mode with separate high-intensity brake and low-level running light functions. Each fixture houses ten high-output LEDs behind a snap-on reflector lens and carries an IP67 rating for dust and water protection. The lights operate on 12 V DC systems and install with a four-wire harness.
Fleet operators, RV owners, boat trailer builders and heavy-duty truck workshops can use these markers as tail, brake, running, turn, clearance or identification lamps across trucks, campers, buses, ATVs, tractors and snowmobiles. Buyers who need a different lens colour, a non-strobe variant or a voltage other than 12 V DC should look at alternative listings.
The harness assigns black to ground, red to high-brightness brake or turn signal, yellow to low-brightness tail or running light, and blue to the strobe emergency mode, letting a single fixture cover three distinct signalling roles.
Measured against everything we stock in 12V LED Lights & Light Bars, at today’s prices. Recalculated every night.
No published specifications for this item yet.
Apply 12 V DC power; the blue wire activates the strobe warning flash, the red wire drives the high-intensity brake/turn output, and the yellow wire produces the low-level tail/running glow — each mode lights its own LED segment so you can confirm operation visually.
The box contains 10 red 4-inch rectangular clearance lights with snap-on reflector lenses and pre-attached 4-wire pigtails (black ground, red high, yellow low, blue strobe); you only need a 12 V DC supply and basic wiring tools — no separate resistors, relays or controllers are required.
Every unit in the 10-piece kit shares the same 10-LED array, IP67 rating and 4-wire interface; there are no alternative capacities or firmware versions, so any light can serve as brake, tail, strobe or marker on any 12 V trailer, boat, RV or truck.
More in 12V LED Lights & Light Bars
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?