Brute Networks 370-ACFT-BN 16GB DDR4-2133 ECC UDIMM

16GB DDR4-2133 ECC UDIMM for Dell servers

This 16GB DDR4-2133 ECC UDIMM is built for Dell servers and workstations that require registered error-correcting memory. It matches Dell part number 370-ACFT and uses major-brand chips from Samsung, SK Hynix or Micron. The module runs at 1.20V with a CAS latency of 15.

288-pin installation with validated compatibility

Installation follows the standard 288-pin DDR4 UDIMM procedure; the module is unregistered so it fits directly into compatible Dell DIMM slots. Brute Networks validates every stick for 100% compatibility and supplies identically matched modules to avoid mixing ranks or chip revisions. Mismatched memory from other sources is the typical cause of boot failures or instability.

DDR4-2133 bandwidth and density limits

The PC4-17000 interface caps throughput at 17000 MB/s, so workloads that need higher memory bandwidth will not benefit from faster modules unless the platform supports them. A single 16GB 2Rx8 rank configuration limits total capacity by the number of available slots and the memory controller's maximum supported density. Systems requiring larger per-module capacities or higher speeds must use a different memory generation.