Cameron Sino 3000mAh 4.8V NiZn Battery BP130 for ScopeMeter 123 124

Compatible ScopeMeter replacement

This 3000mAh nickel-zinc pack replaces the original BP130 battery in Fluke ScopeMeter 123, 123S, 124 and 124S models. It delivers 4.8 volts and 14.40Wh for field measurements, equipment testing and survey work. Technicians who need a direct-fit power source for these specific handheld scopes will find it matches the factory specifications. It is not for users of other ScopeMeter series or instruments requiring a different voltage or connector.

Simple swap with decoded chip

The pack includes a fully decoded chip so the meter recognises it immediately and no firmware steps are required. Installation consists of opening the battery door, disconnecting the old pack and plugging the new connector in; many online videos demonstrate the procedure. The main risk is reversing the connector or using a low-quality charger, both of which can damage the protection circuit. Buyers who cannot access the battery compartment or lack a suitable charger should seek professional fitting.

3000mAh capacity for extended sessions

At 3000mAh the pack supports long measurement sessions before a recharge is needed, and the integrated protection guards against overcharge, over-discharge and short circuits. Runtime scales with display brightness and acquisition rate, so heavy triggering or continuous logging will deplete it faster. The chemistry performs best after two or three full charge cycles and should not be stored above 60°C. Users needing multi-day logging without mains access will require a spare pack or external power.