Cameron Sino A2000 BIS Monitoring Battery 2000mAh 7.2V Ni-MH

Direct replacement for System monitoring units

This Cameron Sino battery replaces the original power pack in System A2000 BIS and BIS View monitoring devices. It matches the 7.2 V, 2000 mAh nickel-zinc specification and fits the 100.50 x 46.50 x 18.50 mm compartment. The decoded chip communicates with the host exactly like the factory cell. Technicians servicing clinical or industrial monitors use this pack to restore mobile operation.

Upgrades ageing Ni-MH packs that no longer hold

The jump is worth it when the original battery drops below useful runtime or shows swelling. Nickel-zinc chemistry delivers the same voltage window while offering a flatter discharge curve, so the monitor reports remaining capacity more accurately. No firmware update or hardware modification is required; the connector mates with the existing socket. Units still running on depleted cells gain full portable runtime again.

Sustained discharge stays stable through a full

Under continuous load the voltage holds steady until the final minutes, avoiding the early sag that triggers premature low-battery alerts. The integrated protection circuit guards against over-charge, over-discharge, over-voltage and short-circuit events during long sessions. After two to three full cycles the pack reaches its rated 14.40 Wh capacity. Storage below 60 °C preserves cycle life between uses.