Camvate C-Clamp 1/4"-20 3/8"-16 Red T-Handle camcorder accessory

Secure C-Clamp for Camera Rigs

The Camvate C-Clamp attaches to surfaces between .12 and 1.65 inches thick, giving camera operators a solid mounting point for monitors, lights or accessories. Dual 1/4-20 and 3/8-16 threaded holes accept standard rig components without adapters. The red T-handle provides leverage for fast, tool-free tightening on set.

Replaces Loose or Single-Thread Clamps

This clamp upgrades from basic mounts that offer only one thread size or rely on thumb screws that can slip under vibration. The jump is worth it when you need both 1/4-20 and 3/8-16 options on the same arm and a handle that stays grippable with cold or gloved hands. Builders who need a wider jaw spread or a baby-pin receiver will not find those features here.

Limited by Jaw Opening and Thread Depth

The 1.65-inch maximum opening restricts use to thin profiles such as table edges, speed-rail or light stands; thicker beams or pipes require a different clamp. Aluminium and plastic construction handles typical monitor and accessory loads but is not rated for heavy cinema cameras or dynamic gimbal forces. Thread engagement depth follows the 1/4-20 and 3/8-16 standards, so very short screws may not reach full purchase.