Carol C4066A.41.10 electrical box, unshielded comm cable 22/6 1000 ft
Unshielded 22 AWG stranded communication cable, six conductors, 1000 ft reel in a box, CM rated for 300 V
- Product typeWire & Cable
- 1000 ft reel covers long runs without splices
- 22 AWG stranded conductors flex easily for tight pulls
- Unshielded design simplifies termination in low-noise environments
- CM-rated jacket meets NEC Article 800 for commercial installs
- Gray PVC jacket resists abrasion and identifies circuits quickly
Carol C4066A.41.10 communication cable
This Carol C4066A.41.10 cable is an unshielded communication wire supplied on a 1000 ft reel in a box. It contains six stranded conductors at 22 AWG with S-R PVC insulation and a grey PVC jacket. The cable carries a CM fire rating under NEC Article 800 and a maximum voltage rating of 300 V.
Installers running audio.
This product suits installers pulling communication, audio or control system wiring in commercial environments where a CM-rated, unshielded cable is specified. It is not for applications that require shielded conductors, a higher fire rating such as CMP or CMR, or a different conductor count or gauge than the six 22 AWG strands provided.
Unshielded six-conductor 22 AWG construction
The single specification that decides fit is the unshielded, six-conductor 22 AWG stranded design with a 0.2 in outside diameter. Buyers needing shielding, a different pair count, a plenum rating or a voltage rating above 300 V must select a different cable type.
How it compares
Measured against everything we stock in Electrical Enclosures & Cabinets, at today’s prices. Recalculated every night.
- Price $573.99
- Pricier than about 90% of the 1,411 comparable items (median $39.99).
Specifications
| Product | |
|---|---|
| Brand name | CAROL |
| Product type | Wire & Cable |
Questions about this item
What outside diameter does the cable have for conduit fill calculations?
The cable measures 0.2 in outside diameter, so use that figure when sizing conduit or raceway.
How should the reel-in-a-box be handled during the pull to avoid kinks?
Place the box on a flat surface, pull straight off the reel without twisting, and feed the cable smoothly into the run.
When should the cable be inspected or replaced after installation?
Inspect the PVC jacket for cracks or discoloration after any overload event or if the 300 V rating is exceeded.
More in Electrical Enclosures & Cabinets
Similar items
TRENDnet TI-CA4K IP68 Outdoor Electrical Box 350W
- Switches
- • Supports up to 16…
HOFFMAN A12106NFSS 304 Stainless Steel Electrical Box 12.0 x 10.0 x 6.0 in
- Electrical Boxes &…





