We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Cle-Line C20738 19/32 inch 118 degree silver and deming drill with half inch reduced shank

Cle-Line

Cle-Line C20738 19/32 in 118 Degree Silver & Deming Drill 1/2 Reduced Shank

SKU CH-AGMA-JY80W

A 19/32 in high-speed steel drill bit with a 118-degree point angle, black oxide finish, and 1/2 in reduced shank for larger chucks

  • Product typeDrill Bits
  • 19/32 in diameter drills large holes
  • 118 degree point angle centres quickly
  • High-speed steel resists heat wear
  • Black oxide finish reduces friction
  • 1/2 in reduced shank fits standard chucks

Application Fit

The Cle-Line C20738 is a silver and deming drill bit with a 19/32 inch diameter and a 1/2 inch reduced shank. It is built for machinists and maintenance technicians who need to drill holes larger than a standard chuck capacity allows. The high-speed steel construction suits general-purpose metal cutting in workshop and job-site environments.

Upgrade Path

This bit replaces smaller-diameter twist drills when a 19/32 inch hole is required without stepping up to a larger chuck or Morse taper tool. The reduced shank lets you run the size in a common 1/2 inch three-jaw chuck, avoiding the cost and setup time of a dedicated large-capacity drill press. The jump is worth it when hole count justifies a dedicated large-diameter bit over reaming or step-drilling.

Sustained Use

The 118 degree point angle and black oxide finish work together to manage heat and resist wear during extended drilling cycles in steel and cast iron. High-speed steel retains hardness at the temperatures reached in prolonged cuts, while the oxide surface holds coolant and reduces galling. Consistent feed pressure and proper lubrication keep the bit cutting cleanly through deep holes without premature edge breakdown.

How it compares

Measured against everything we stock in Bits, Hole Saws & Accessory Kits, at today’s prices. Recalculated every night.

Price $15.99
Cheaper than about 73% of the 5,493 comparable items (median $27.99).

Specifications

Product
Brand nameCLE-LINE
Product typeDrill Bits

Questions about this item

Will the 1/2 reduced shank fit my drill chuck?

The 1/2 reduced shank is designed to fit standard drill chucks that accept a 1/2 inch shank diameter.

How do I properly install the 19/32 in drill bit and avoid the common mistake?

Insert the reduced shank fully into the chuck and tighten securely on the shank flats, not the flutes, to prevent slippage during drilling.

When will the 118 degree point on this high speed steel bit need resharpening or replacement?

Resharpen the 118 degree point when cutting edges dull or chip; replace the bit if the shank wears or the flute length shortens from repeated sharpening.

More in Bits, Hole Saws & Accessory Kits

Similar items