We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Cleveland C80382 carbide end mill, .375 inch diameter, 3 flute, TiAlN coated

Cleveland

Cleveland C80382 Carbide End Mill .375 in 3FL

SKU CH-9TEA-7ZSV6

Carbide centre-cutting end mill with 0.375 in diameter, three flutes and 0.02 in corner radius

  • Product typeMilling
  • Carbide construction resists wear for longer tool life
  • 375 in diameter suits 3/8 inch milling tasks
  • Three-flute design improves chip evacuation in slots
  • TiAlN coating reduces friction and heat buildup

Cleveland C80382 Carbide End Mill

The Cleveland C80382 is a solid carbide end mill designed for general milling operations. Its three-flute geometry and TiAlN coating suit machinists and maintenance teams cutting steel or stainless alloys. The 0.375 inch diameter and 0.875 inch length of cut fit standard tool holders and CNC setups.

Capacity and headroom

The 0.02 inch corner radius adds edge strength for light profiling and slotting in medium-hard materials. The 2.5 inch overall length limits reach in deep cavities or tall workpieces. The fixed three-flute design restricts chip evacuation in heavy roughing or wide full-width cuts. Buyers needing extended reach or higher flute counts for finishing should consider other tooling.

How it compares

Measured against everything we stock in Bits, Hole Saws & Accessory Kits, at today’s prices. Recalculated every night.

Price $34.99
Pricier than about 57% of the 5,493 comparable items (median $27.99).

Specifications

Product
Brand nameCLEVELAND
Product typeMilling

Questions about this item

Will the 0.375 in diameter shank fit the collet on my older CNC router?

The end mill has a 0.375 in shank diameter, so it will fit any collet or holder sized for 3/8 in tooling.

How can I verify the TiAlN coating is performing correctly after the first cuts?

Inspect the cutting edges for a consistent gold-purple hue and check that chips are coming off clean without built-up edge on the carbide flutes.

More in Bits, Hole Saws & Accessory Kits

Similar items