We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Cleveland C96108 spiral point tap #8-32 UNC cobalt black oxide finish three flutes

Cleveland

Cleveland C96108 #8-32 UNC spiral point tap 3 flutes

SKU CH-X4D7-A85MY

A #8-32 UNC spiral point tap with three flutes, cobalt construction and black oxide finish for right-hand threading

  • #8-32 UNC thread cuts cleanly in through-holes
  • 3-flute spiral point pushes chips forward for smooth tapping
  • Cobalt steel with black oxide resists wear in tough materials
  • 2 31/64 in overall length reaches deeper threads
  • 75 % thread drill size 3.40 mm guides accurate hole prep

Cleveland #8-32 UNC spiral point tap

This Cleveland C96108 is a cobalt spiral point tap with three flutes for #8-32 UNC threads. It measures 2 31/64 inches overall with a 53/64 inch thread length and a 2B class of fit. The black oxide finish adds wear resistance for general machine tapping.

Suited for through-hole threading in steel

The spiral point design pushes chips ahead of the tap, making it effective for through-hole work in ferrous materials. It is not intended for blind holes where chips must be lifted out, nor for hand tapping without a machine spindle. Buyers needing a bottoming or plug chamfer for blind holes should select a different tap geometry.

75 percent thread drill size 3.40 mm

The 75 percent thread engagement requires a 3.40 mm drill size to produce the correct 2B class of fit. Using a different drill diameter will change the thread percentage and may cause oversize or undersize threads. Verify the drill size before starting the job.

How it compares

Measured against everything we stock in Bits, Hole Saws & Accessory Kits, at today’s prices. Recalculated every night.

Price $12.99
Cheaper than about 82% of the 5,493 comparable items (median $27.99).

Specifications

Product
Brand nameCLEVELAND

Questions about this item

How do I install the #8-32 UNC spiral point tap and what step is often missed?

Use a 3.40 mm drill for the 75 percent thread hole, then run the tap straight with cutting fluid; the step many skip is clearing chips every half-turn to avoid binding in the 53/64 in thread length.

What maintenance or replacement will the Cleveland C96108 tap need later?

The cobalt body with black oxide coating resists wear, but the three flutes will dull after repeated use; replace the tap when threads show tear-out or the 2B class of fit can no longer be held.

What limit appears first when tapping deeper holes under sustained use?

Chip evacuation in the 53/64 in thread length becomes the limiting factor; packed flutes increase torque and can break the tap before the 2 31/64 in overall length is reached.

More in Bits, Hole Saws & Accessory Kits

Similar items