CMT 806.064.11 Flush Trim Profile Router Bit 1/4 in carbide

CMT 806.064.11 Flush Trim Router Bit

This CMT 806.064.11 router bit is a flush trim profile tool with a 1/4 inch carbide cutter. It is designed for precision trimming tasks in a workshop or on a job site. The bit suits woodworkers and joiners who need a reliable profile cutter for laminate or template work. It arrives new and ready for immediate use in a compatible router.

Suited for template profiling.

This bit suits users following a bearing-guided template to trim edges flush with a substrate. It is not for hogging out large volumes of material or cutting deep mortises in a single pass. Builders who need a straight plunge bit or a large diameter panel cutter should look at a different tool. The carbide tip resists wear on abrasive laminates and hardwoods.

1/4 inch carbide cutter diameter decides fit

The single specification that decides compatibility is the 1/4 inch cutter diameter. Your router collet must accept a 1/4 inch shank and the project must require this exact cutting width. If the job demands a wider or narrower profile, this bit will not produce the correct result. Verify the collet size and profile requirement before ordering.