We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
CMT V-groove router bit with 1/2 inch shank, carbide tip, silver finish

CMT

CMT 815.127.11 V-groove router bit 1/2 in shank

SKU CH-HSFG-JCQE8

Carbide-tipped V-groove router bit with 1/2 in shank for clean decorative cuts

  • Clean V-groove cuts with carbide-tipped precision
  • 1/2 in shank fits standard routers
  • Carbide tip resists wear for longer life
  • V-groove profile creates decorative edges
  • CMT brand trusted by woodworkers

1/2 in shank V-groove router bit

This carbide-tipped router bit from CMT cuts clean V-groove profiles with a 1/2 inch shank for stable mounting. It is suited for woodworkers and cabinetmakers who need precise decorative grooves or joinery details in solid wood and panel materials.

Replaces worn or smaller-shank bits

A fresh 1/2 inch shank bit eliminates vibration that dulls 1/4 inch shank alternatives and restores crisp edge definition on ageing cutters. The upgrade is worth it when groove consistency matters more than occasional trim work.

Check collet compatibility and router power

Verify your router accepts a 1/2 inch shank and delivers enough torque for the cutter diameter shown in the specifications. Confirm the cutting depth matches your project requirements before ordering.

How it compares

Measured against everything we stock in Bits, Hole Saws & Accessory Kits, at today’s prices. Recalculated every night.

Price $15.99
Cheaper than about 73% of the 5,493 comparable items (median $27.99).

Specifications

Product
Brand nameCMT

Questions about this item

What collet size does the 1/2 in shank require on my router?

The bit has a 1/2 in shank, so the router must accept a 1/2 in collet or a reducer sleeve that grips the full shank length.

How deep should the 1/2 in shank be seated before tightening the collet?

Insert the shank until the flute base nearly touches the collet face, then pull back slightly and tighten; this avoids bottoming out and ensures full grip.

When does the carbide tip on this V-groove bit need replacing?

Replace the bit when the carbide edges show visible chips, the cut leaves burn marks, or feed resistance increases sharply during use.

More in Bits, Hole Saws & Accessory Kits

Similar items