Datalogic 90G001092 RS-232 Serial Cable 6 ft pos accessory

Datalogic RS-232 Serial Cable

This six-foot cable connects a Datalogic Gryphon I GBT4100 scanner to a host system using a standard RS-232 serial link. It is built for point-of-sale environments where reliable wired communication is required. The part number 90G001092 identifies the exact accessory for this device family.

Build Quality and Daily Use

The cable carries a DB-9 style connector on the host side and a modular plug for the scanner cradle, allowing a secure fit that resists accidental disconnection during checkout traffic. A six-foot run gives enough slack to route the wire along a counter or through a stand without stretching. The moulded strain relief protects the solder joints from repeated flexing at both ends.

Critical Compatibility Check

This accessory works only with the Gryphon I GBT4100 model; it will not fit other Gryphon series scanners or third-party hardware. Verify the scanner part number before ordering to avoid a mismatch. No driver installation is needed because the link uses the native RS-232 protocol supported by the host application.