We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small copper wire rope stop sleeves zinc plated pack of 50

Dayton

Dayton Wire Rope Stop Sleeve 3/32 in Copper PK50

SKU CH-C65B-RYGQZ

Copper stop sleeves terminate 3/32 in wire rope with swage fittings in a 50-piece pack

  • Product typeAlignment Tools
  • Copper construction resists corrosion for lasting performance
  • 3/32 in compatibility fits standard wire rope sizes
  • 3/8 in overall length provides compact termination
  • Swage fitting type ensures secure mechanical connection
  • Pack of 50 sleeves supports multiple project needs

What It Is

The Dayton wire-rope stop sleeve is a copper fitting sized for 3/32 in rope and supplied in a pack of 50. It is intended for technicians and assemblers who need a simple swage stop on light-duty cables.

Build and Fit

Each sleeve measures 3/8 in overall length with a 3/8 in outside diameter and carries a zinc-plated finish for corrosion resistance. The swage-style fitting is crimped onto the rope end to prevent pull-through during tensioning.

Use Limits

The sleeve is rated not for lifting, so it suits static positioning, guying or barrier cables rather than load-bearing hoists. No load-efficiency figure or applicable standard is published for this fitting.

How it compares

Measured against everything we stock in Utility & Specialty Hand Tools, at today’s prices. Recalculated every night.

Price $25.99
Typical for this category: the median of 2,474 items is $23.99.

Specifications

Product
Brand nameDayton
Product typeAlignment Tools

Questions about this item

What rope diameter does the 3/32 in stop sleeve swage onto?

The sleeve swages onto 3/32 in wire rope and has a 3/8 in overall length with a 3/8 in outside diameter.

What tooling or clearance is needed to install these copper sleeves?

A swaging tool sized for 3/32 in sleeves is required; the finished assembly fits a 3/8 in outside diameter.

How are the sleeves swaged and what is the common mistake?

Insert the rope, position the sleeve, then compress fully with a swager; the common error is partial compression leaving a loose fit.

More in Utility & Specialty Hand Tools

Similar items