DBPOWER WF-NW-40M 131ft 4000K 24V Under Cabinet

131ft 4000K LED strip kit

This 131-foot LED strip kit ships as two 65.6-foot rolls with 1920 SMD 2835 LEDs in a 4000K natural white tone. The CRI 90+ output suits kitchens, cabinets, shelves and bedroom accent lighting where accurate colour rendering matters. An RF remote and inline controller provide six dimming levels, four preset brightness steps and three dynamic modes plus 10/30/60-minute timers. The 24V 48W power adapter, 8mm two-pin connectors and mounting clips are included so installation can start immediately.

24V IP20 indoor limits

The strip runs on 24V DC from a 100-240V AC adapter rated at 48W, so total run length must stay within that power budget. Cutting points occur every 1.97 inches (5 cm), allowing precise trimming without damaging the circuit. IP20 rating means the tape is not waterproof and must stay in dry indoor locations; moisture exposure will cause failure. The 8mm width fits standard low-profile channels but cannot be submerged or used outdoors. RF control requires line-of-sight to the controller; thick walls or metal cabinets may reduce range.

Check power and mounting surface

Verify that a mains socket is available near the planned start point for the 24V adapter. The mounting surface must be clean, dry and smooth so the pre-applied adhesive bonds reliably; dusty or textured surfaces may need the supplied clips. Confirm the 8mm width fits any aluminium channel or recess you intend to use. Ensure the installation area stays within the IP20 dry-indoor limitation — bathrooms, kitchens splash zones or covered patios are unsuitable. No additional accessories are required beyond what the kit provides.