DBTLAP E1033X12BYAP-26 9733 12V 1.20A 4pin centrifugal turbo blower cooling fan
- Cooler
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Replacement GPU cooling fan for select HP ENVY 15-DS and 15M-DS series laptops, tested before shipping
This DBTLAP GPU cooling fan replaces the original cooler in HP ENVY 15-DS and 15M-DS series laptops. It fits the 15-DS0003CA, 15-DS0013CA, 15M-DS0011DX and 15M-DS0012DX models. The part also supports the 15-DS0013NR, 15M-DR1011DX and 15M-DR1012DX variants. Each unit is tested before dispatch.
Install this fan when the original GPU cooler becomes noisy, stops spinning or causes thermal throttling. The swap restores factory cooling performance without modifying the heatsink assembly. Verify the part visually against the product photos before ordering. Contact the seller with your exact model number if you are uncertain about fitment.
This cooler suits owners of the specific HP ENVY models named above who need a direct replacement GPU fan. It is not for users with other HP series, different chassis sizes or discrete graphics configurations not listed. Buyers who cannot confirm their model number against the compatibility list should seek an alternative part.
Measured against everything we stock in Laptop Cooling Stands & Fans, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Accessory category | Cooler |
The fan is listed for HP ENVY 15-DS and 15M-DS series including 15-DS0013CA. Compare the photos with your original fan to confirm the connector and screw layout match.
Disconnect the battery first, then remove the heat-pipe assembly to reach the GPU fan. The step often missed is re-seating the thermal pads on the VRAM and GPU die before tightening the heat-pipe screws.
Clean dust from the heatsink fins every 6–12 months with compressed air. Replace the fan if bearing noise appears or RPM drops below spec, typically after 2–3 years of heavy use.
More in Laptop Cooling Stands & Fans
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?