DBTLAP laptop cooling fan for HP X360 M3-U101DX M3-U103DX M3-U105DX

Replacement CPU fan for HP X360 M3 models

This replacement cooling fan fits HP X360 M3-U101DX, M3-U103DX, M3-U105DX and related M3 series laptops. It is a direct swap for the original CPU cooler when that part has failed or become noisy. The unit is sold individually and intended for single-fan configurations only. Buyers who need a dual-fan assembly or a complete heatsink module should look elsewhere.

Upgrade from a worn or loud original cooler

The jump is worth it when the existing fan spins unevenly, rattles or stops entirely under load. Each unit is tested before dispatch to confirm it runs correctly. Because the manufacturer may supply Forcecon, ADDA, Sunon, Kipo or an equivalent brand depending on stock, the exact motor may differ from the one currently installed. Builders who require a specific brand or a higher airflow rating than the original specification cannot be accommodated.

Straightforward swap with careful alignment

Installation follows the standard laptop teardown: remove the bottom case, disconnect the old fan cable and secure the new unit in the same mounting points. The connector and screw pattern match the factory layout, but the cable routing must be tucked exactly as before to avoid pinching. The most common issue is ordering the wrong variant for a slightly different M3 chassis, so verify the part number against the original before purchasing.