DBTLAP E1033X12BYAP-26 9733 12V 1.20A 4pin centrifugal turbo blower cooling fan
- Cooler
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Replacement 5V 0.5A cooling fan compatible with B7307ASHNF2200TN and 023.100TV.0011 A01 laptops
This DBTLAP cooling fan is a direct replacement part for laptops using the B7307ASHNF2200TN 023.100TV.0011 A01 component. It is intended for owners of compatible machines who need to restore original cooling performance after a fan failure. Buyers who cannot verify their exact part number against the listed code should not purchase this item.
The unit arrives as a single fan module without extra brackets or cables, matching the form factor of the original component. Its compact size allows it to fit inside the tight chassis spaces for which it was designed. Installation requires access to the laptop interior and the correct screw pattern, so builders without disassembly experience or the proper tools may find the swap difficult.
Rated at 5V and 0.5A, the fan draws minimal power from the system header during normal use. This low current keeps heat output from the motor itself very small. Acoustic behaviour will depend on the laptop’s fan curve and bearing condition, but the design targets quiet operation at typical speeds. Each unit is tested before shipping to confirm basic function.
Measured against everything we stock in Laptop Cooling Stands & Fans, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Accessory category | Cooler |
The fan runs on a 5 volt supply drawing 0.5 amps; match the original connector shown in the product photos to ensure correct polarity.
Compare the replacement fan's mounting holes and overall outline with the original unit in the listing images; only an exact match guarantees proper fit.
Disconnect the battery, release the cable latch gently, remove the old fan screws, install the new fan, then reseat the ribbon before powering on.
More in Laptop Cooling Stands & Fans
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?