DBTLAP E1033X12BYAP-26 9733 12V 1.20A 4pin centrifugal turbo blower cooling fan
- Cooler
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Replacement heatsink with fan for HP DL580 G7, matching part numbers 570259-001 and 591207-001
This DBTLAP cooler is built as a direct replacement for the HP DL580 G7 server using part numbers 570259-001 and 591207-001. It arrives new and tested, ready for installation in compatible systems. The package includes one fan unit. Verify the photos against your existing heatsink before ordering.
The part replaces an aged or failed factory heatsink that no longer dissipates heat effectively. Swapping it out restores the thermal performance the chassis was designed for. The jump is worth it when the original cooler shows excessive noise, rising temperatures or physical damage. Buyers needing a different form factor or additional fans should look elsewhere.
The single-fan assembly handles the heat load specified for the supported HP DL580 G7 configuration. It provides adequate airflow for standard operating conditions within that platform. Headroom diminishes if the server runs sustained maximum workloads or if the chassis airflow is restricted. The cooler is not suited for multi-processor upgrades beyond the original specification.
Measured against everything we stock in Laptop Cooling Stands & Fans, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Accessory category | Cooler |
Yes, it is made for the HP DL580 G7 and matches part numbers 570259-001 and 591207-001; compare the photos with your old heatsink before ordering.
Remove the old cooler, clean the CPU surface, apply fresh thermal paste, seat the new heatsink evenly, tighten screws in a cross pattern, then connect the fan cable.
The fan is the moving component; it will wear out before the heatsink and should be replaced when noise increases or airflow drops.
More in Laptop Cooling Stands & Fans
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?