DBTLAP E1033X12BYAP-26 9733 12V 1.20A 4pin centrifugal turbo blower cooling fan
- Cooler
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Replacement CPU cooler compatible with multiple MSI laptop series including CX61, CR650 and FX models
This new DBTLAP cooling fan replaces the original unit in compatible MSI models including CX61, CR650, FX600, FX610, FX603, FX620 and GE620 series. It is built for owners who need a direct swap to restore proper airflow after a failure. Buyers with different laptop brands or unlisted MSI chassis should verify fitment before ordering.
Every fan is tested individually before dispatch to confirm 100 percent operation under sustained load. The component is designed to maintain steady airflow during extended sessions rather than brief bursts. A nine-month warranty backs the reliability of each tested unit.
The fan runs quietly during typical workloads while drawing minimal power from the laptop board. No radiator dimensions or specific decibel ratings are provided, so exact acoustic figures cannot be stated. Users should match the part visually to the original Forcecon, ADDA, Sunon or Kipo unit shown in the listing photos.
Measured against everything we stock in Laptop Cooling Stands & Fans, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Accessory category | Cooler |
The replacement fan is built to match the original MSI specification, so it draws the same low power as the factory unit and will not increase battery drain during all-day operation.
Your notebook must be one of the listed MSI models — CX61, CR650, FX600, FX610, FX603, FX620, FX620DX, GE620 or GE620DX — with the matching CECON mounting points and connector.
Yes, the fan is produced to the same 052610A and DFS451205M10T dimensions used on the FX600, so the original heatsink, screw pattern and connector align without modification.
More in Laptop Cooling Stands & Fans
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?