DBTLAP E1033X12BYAP-26 9733 12V 1.20A 4pin centrifugal turbo blower cooling fan
- Cooler
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Cools Samsung X05, X10, X15, X30, M40 and M50 laptops with a 3‑pin connector
This cooler is built as a direct replacement for the original CPU fan in several Samsung laptop series. It uses a three-pin connector that matches the motherboard header on the listed models. Each unit is tested individually before dispatch to confirm it spins correctly. Buyers who need a fan for a different laptop line or a four-pin PWM connector will not find a match here.
The part replaces the factory cooler when it stops spinning, runs loudly or overheats the processor. Swapping it restores normal thermal performance without changing the laptop's design. The improvement is worth it when the original fan has worn bearings or blocked airflow. If the chassis vents are clogged or the heatsink is damaged, a new fan alone will not solve the temperature rise.
Installation involves opening the laptop, removing the old fan and plugging the new unit into the same three-pin header. No soldering or adapter cables are required. The most common issue is ordering the wrong variant; the supplier advises comparing the product photos with the original fan before purchase. Another frequent problem is forgetting to clean old thermal paste off the heatsink during reassembly.
Measured against everything we stock in Laptop Cooling Stands & Fans, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Accessory category | Cooler |
The fan uses a 3-pin connector designed for the Samsung X05, X10, X15, X30, M40 and M50 models; verify the header layout on your original fan before fitting.
Align the label side toward the exhaust vent so the airflow direction matches the original cooler; the mounting screw holes only line up in that orientation.
Blow dust from the intake vents every few months; if the fan develops noise or vibration after extended use, replace the whole unit as bearings are not serviceable.
More in Laptop Cooling Stands & Fans
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?