Seagate BarraCuda ST8000DM004 8TB 5400 RPM 256MB SATA 3.5" internal hard drive
- 8 TB
- SATA 6.0Gb/s
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
4 TB 3.5" SAS hard drive spins at 7200 RPM with a 12 Gb/s transfer rate and hot-swap tray
This 3.5-inch internal hard drive provides 4TB of storage on a SAS interface spinning at 7200 RPM. It is built for nearline workloads in Dell servers and storage arrays where hot-swap capability is required. The bare-drive packaging suits system integrators and IT departments replacing or expanding existing drive bays.
The 12Gb/s transfer rate doubles the throughput of 6Gb/s nearline drives, cutting backup windows and speeding sequential reads for archival workloads. The jump is worth it when the controller and backplane both support 12Gb/s; on a 6Gb/s backplane the drive will negotiate down and the extra headroom goes unused.
The interface tops out at 12Gb/s, so sustained throughput cannot exceed the electrical signalling limit regardless of spindle speed. Cable length, backplane design and controller firmware all introduce real-world overhead that reduces effective bandwidth below the nominal rate. Buyers needing higher random IOPS or lower latency should evaluate solid-state alternatives.
Measured against everything we stock in 3.5-Inch Internal Desktop HDDs, at today’s prices. Recalculated every night.
New to this? Paying with USDT: TRC-20 or ERC-20 — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Dell |
| Model name | 400-ALQC |
| Total capacity | 4 TB |
| Performance | |
| Rotational speed | 7,200 RPM |
| Mean latency | 3Gb/s |
| Ports & slots | |
| Interface type | SAS 3Gb/s |
| Size & build | |
| Form factor | 3.5 in (8.89 cm) |
The 3.5" form factor matches standard internal drive bays; ensure your chassis accepts 3.5" SAS drives.
Slide the drive into the hot-swap tray until the SAS connector seats firmly; the common mistake is stopping before the latch clicks.
Replace the drive if SMART reports reallocated sectors or if sustained throughput drops below expected 7200 RPM levels.
More in 3.5-Inch Internal Desktop HDDs
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?