Seagate BarraCuda ST3000DM008 3TB 7200 RPM 64MB SATA 6.0Gb/s 3.5" internal hard drive
- 3 TB
- SATA 6.0Gb/s
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A 2.5" SAS drive spinning at 10000 RPM with 146GB capacity for server workloads
The Dell X160K-CO2 is a 146GB 2.5-inch internal hard drive spinning at 10000 RPM. It uses a Serial Attached SCSI (SAS) interface for direct connection to compatible server backplanes. The drive is supplied new and tested with updated firmware. It is designed for deployment in enterprise server environments.
This drive suits administrators refreshing or expanding storage arrays that specifically require 146GB SAS units at 10000 RPM. It fits hot-swap bays designed for 2.5-inch SAS form factors. Buyers who need more storage capacity per drive should look at higher-capacity models. Systems lacking a SAS controller or backplane cannot use this drive.
The single specification that decides suitability is the 146GB capacity. A server slot or array rebuild requiring exactly this capacity will accept the drive. Any requirement for a different total capacity makes this model the wrong part regardless of its speed or interface.
Measured against everything we stock in 3.5-Inch Internal Desktop HDDs, at today’s prices. Recalculated every night.
New to this? Paying with USDT: TRC-20 or ERC-20 — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Dell |
| Model name | X160K |
| Total capacity | 146 GB |
| Recommended use | Ideal for Servers |
| Performance | |
| Rotational speed | 10,000 RPM |
| Ports & slots | |
| Interface type | Serial Attached SCSI (SAS) |
| Size & build | |
| Form factor | 2.5 in (6.35 cm) |
The 2.5" form factor matches standard 2.5" SAS hot-swap bays used in Dell PowerEdge servers; verify the tray or caddy matches your chassis.
Inserting the drive before the backplane is fully seated or neglecting the SAS connector alignment pin causes detection failures; press firmly until the latch clicks.
Replace the drive when SMART reallocated sectors rise above the vendor threshold or after a predictive failure alert during routine array scrubbing.
More in 3.5-Inch Internal Desktop HDDs
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?