Drill America DAM Series Carbide-Tipped Masonry Drill Bit 3/4" 6" Black Oxide Round Shank 118° Point

Carbide-Tipped Masonry Bit

The Drill America DAM series bit is a carbide-tipped masonry drill bit built for brick, concrete and sandstone. It fits portable electric drills and uses a 1/2 inch round shank for standard chucks. The black oxide finish adds corrosion resistance. Contractors and DIY users drilling anchor holes in masonry will find it suited to the task.

6-Inch Overall Length

The bit measures 6 inches overall, giving enough reach for typical anchor, expansion shield and toggle bolt installations. Wide spiral flutes clear dust quickly in softer masonry so the hole stays clean. Carbide tips are brazed to tough steel bodies and ground larger than nominal size to provide clearance for fasteners. Very hard aggregate or reinforced concrete will wear the cutting edges faster than softer brick.

118-Degree Conventional Point

The 118-degree conventional point is the single specification that decides whether this bit matches the application. It centres reliably in masonry without walking and cuts efficiently in brick, block and sandstone. Buyers who need a split-point geometry for harder stone or a reduced-shank design for smaller chucks should select a different bit.