We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver cylindrical HSS annular cutter with pilot pin, 13/16 inch diameter

Drill America

Drill America DWC5-530-124 HSS annular cutter 13/16" x 1" with pilot pin

SKU CH-R239-1CBYW

13/16 inch HSS annular cutter with pilot pin for magnetic drill presses, cutting only the material needed for a clean hole

  • Cuts only the hole perimeter for fast material removal
  • High-speed steel construction gives hardness and toughness for wear resistance
  • 3/4" Weldon shank fits magnetic drill presses directly
  • Includes pilot pin for accurate hole alignment
  • California Proposition 65 warning applies to this product

Drill America 13/16 inch annular cutter

This Drill America HSS annular cutter measures 13/16 inch in diameter with a 1 inch depth of cut. It features a 3/4 inch Weldon shank designed specifically for magnetic drill presses. The high-speed steel construction provides hardness and toughness for general-purpose wear resistance. A pilot pin is included with the cutter.

Magnetic drill press operators needing fast holes

This cutter suits users with magnetic drill presses who need to produce quality holes efficiently by cutting only the necessary material. It is not for operators using standard hand drills or conventional drill presses because the Weldon shank is incompatible. Buyers requiring different hole diameters or cutting depths must select another size. The Proposition 65 warning indicates chemical exposure risks.

3/4 inch Weldon shank fitment

The 3/4 inch Weldon shank is the single specification that determines whether this cutter fits your equipment. It locks into magnetic drill presses that accept this shank standard. If your machine uses a different shank interface the cutter will not mount. Verify your press compatibility before purchase.

How it compares

Measured against everything we stock in Bits, Hole Saws & Accessory Kits, at today’s prices. Recalculated every night.

Price $27.99
Typical for this category: the median of 5,493 items is $27.99.

Specifications

Product
Brand nameDRILL AMERICA

Questions about this item

How do I install the 13/16" annular cutter into a magnetic drill press without damaging the 3/4" Weldon shank?

Align the cutter's 3/4" Weldon shank flat with the chuck set screw, insert fully until it seats, then tighten the set screw firmly against the flat; the common error is tightening on the round portion, which lets the cutter slip under load.

When will the high-speed steel cutting edges need replacement or resharpening during regular metal cutting?

Replace or resharpen when the cutter produces rough holes, requires excessive feed pressure, or shows visible flank wear on the 13/16" diameter edges; high-speed steel offers good toughness but wears faster than carbide in abrasive alloys.

What is the first limitation I will hit when running the 13/16" cutter continuously in thick steel plate?

The 1" depth of cut is the hard limit; the cutter cannot plunge deeper than its 1" flute length, so sustained use in thicker material requires step drilling or a longer cutter.

More in Bits, Hole Saws & Accessory Kits

Similar items