We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver cylindrical HSS annular cutter with pilot pin and Weldon shank

Drill America

Drill America DWC5-530-151 annular cutter 1-3/8 in pneumatic accessory

SKU CH-ZGCV-3SXQT

High-speed steel annular cutter creates 1-3/8 inch holes in magnetic drill presses and includes a pilot pin

  • High-speed steel construction resists wear for general-purpose cutting
  • 3/4 inch Weldon shank fits magnetic drill press machines
  • Annular design removes only necessary material for quality holes
  • Pilot pin included for accurate cutter alignment
  • California Proposition 65 warning applies for cancer and reproductive harm

Drill America HSS Annular Cutter

This Drill America DWC5-530-151 cutter is a high-speed steel accessory built for magnetic drill presses. It removes only the material needed to form a clean hole, making it suitable for metal fabrication and maintenance tasks where speed and finish matter.

Upgrade from standard twist bits

Unlike conventional drills that remove the full core, this annular cutter cuts the perimeter for faster penetration and less motor strain. The jump is worthwhile when you need accurate, burr-free holes in structural steel or plate using a mag-drill setup.

For mag-drill operators only

The 3/4 inch Weldon shank fits magnetic drill presses exclusively; it will not work in a hand drill or standard drill press. Buyers needing a cutter for portable drilling machines or non-magnetic bases should look at a different shank style.

How it compares

Measured against everything we stock in Bits, Hole Saws & Accessory Kits, at today’s prices. Recalculated every night.

Price $52.99
Pricier than about 69% of the 5,493 comparable items (median $27.99).

Specifications

Product
Brand nameDRILL AMERICA

Questions about this item

What shank size does the DWC5-530-151 need on the magnetic drill press?

The cutter uses a 3/4" Weldon shank, so the magnetic drill press must accept that shank diameter.

How do I install the pilot pin with this annular cutter?

Insert the pilot pin through the centre of the cutter before mounting it in the magnetic drill press; the pin centres the cut and ejects the slug.

When should the pilot pin be replaced on the DWC5-530-151?

Replace the pilot pin when its tip is worn or bent, because a damaged pin will not centre the cutter or eject the slug cleanly.

More in Bits, Hole Saws & Accessory Kits

Similar items