We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver annular cutter with pilot pin, Weldon shank

Drill America

Drill America DWC5-530-210 annular cutter 7/16" x 2" with pilot pin

SKU CH-JYW0-7Y2NP

High-speed steel annular cutter with 3/4" Weldon shank and pilot pin for magnetic drill press use only

  • High-speed steel withstands general-purpose wear
  • 3/4" Weldon shank fits magnetic drill presses
  • Cuts only material needed for clean holes
  • Pilot pin included for accurate alignment
  • California Proposition 65 warnings apply

Annular cutter for magnetic drill press

The Drill America DWC5-530-210 is a high-speed steel annular cutter built for use with a magnetic drill press. It features a 3/4" Weldon shank that locks directly into the press. The tool is not compatible with standard hand drills or conventional drill presses. It suits metalworkers who need fast, clean holes in structural steel or plate.

Cuts only the hole perimeter under load

In sustained cutting the tool removes material solely around the hole circumference, leaving a solid slug. This reduces the torque and feed force required compared with a solid twist drill of the same diameter. High-speed steel construction balances hardness and toughness for wear resistance during repeated cuts in general-purpose ferrous metals.

Verify press compatibility and safety warnings

Confirm your magnetic drill press accepts a 3/4" Weldon shank before ordering. The cutter must not be used in a hand-held drill or bench-top drill press. California Proposition 65 notices advise that the product contains chemicals known to the state to cause cancer and birth defects or other reproductive harm.

How it compares

Measured against everything we stock in Bits, Hole Saws & Accessory Kits, at today’s prices. Recalculated every night.

Price $28.99
Typical for this category: the median of 5,493 items is $27.99.

Specifications

Product
Brand nameDRILL AMERICA

Questions about this item

Does the 3/4" Weldon shank annular cutter run cool enough for all-day magnetic drilling?

High-speed steel construction resists heat buildup during extended cuts, and the annular design removes only the hole perimeter to reduce friction.

What magnetic drill press do I need for the 3/4" Weldon shank to fit?

Any magnetic drill press with a 3/4" Weldon shank holder accepts this cutter; it will not work in standard drill chucks or hand drills.

Can I keep my older 3/4" Weldon magnetic drill and just swap in this 7/16" cutter?

Yes, the 3/4" Weldon shank matches legacy magnetic drill presses, so the cutter fits directly without an adapter.

More in Bits, Hole Saws & Accessory Kits

Similar items