Premier Mounts PDS-PLUS-W ceiling projector mount
- Ceiling Mount
- Projector
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Replacement lamp with economy bulb for Dukane ImagePro 8910 and 8053 projectors
The 456-226 lamp replaces the original unit in Dukane ImagePro 8910 and ImagePro 8053 projectors. It is supplied new with an economy bulb inside the housing. This accessory restores brightness when the original lamp reaches end of life. Compatible models are limited to the two Dukane projectors listed.
An economy bulb typically delivers lower initial luminance than a premium module and its output decays faster during extended operation. Users should expect a shorter usable lifespan before brightness drops below acceptable levels. The lamp is intended for standard classroom or meeting-room duty cycles. Heavy daily use will accelerate the decline in image quality.
This lamp fits only the Dukane ImagePro 8910 and ImagePro 8053 projectors. It will not operate in other Dukane models or projectors from different brands. The part number 456-226 cross-references to DT00471 for ordering verification. Buyers needing a lamp for any other projector model must source a different part number.
Measured against everything we stock in Projector Mounts & Add-Ons, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Product type | Projector Lamp |
The 456-226 uses an economy bulb built to the same electrical spec as the factory lamp, so heat output and fan noise stay at the level the projector was designed for.
The 456-226 ships as a complete lamp module with housing, so you simply swap the whole unit; no separate cage or tools are required.
The lamp is listed for both the ImagePro 8053 and 8910, matching the original part numbers 456-226 and DT00471, so it strikes and runs at stock brightness on either model.
More in Projector Mounts & Add-Ons
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?