Rosewill RMS-E53 triple monitor mount 15-27" 17.6lb gas spring VESA 75/100 clamp grommet monitor accessory
- Monitor Arms
- Black
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A 15.6-inch WXGA CCFL laptop display panel with a 30-pin connector and 1366x768 resolution
This 15.6-inch CCFL LCD panel delivers a 1366 x 768 WXGA resolution for compatible laptops. It uses a single-bulb cold-cathode backlight and connects through a 30-pin CCFL socket. The screen is built as a direct swap for the original display in supported machines. Buyers needing an LED-backlit panel or a different connector should look elsewhere.
The single CCFL bulb provides consistent illumination once warmed up, avoiding the rapid brightness shifts sometimes seen with ageing tubes. A 30-pin interface carries both video signal and backlight power without a separate inverter cable. The panel is tested for full operation before shipping. Users expecting instant-on LED response will find the warm-up period different.
Verify that the existing screen uses a 30-pin CCFL connector and a single-bulb backlight before ordering. The part matches several manufacturer codes including LTN156AT01 and LP156WH1-TLC1. Laptops fitted with LED panels or 40-pin sockets cannot accept this unit. Confirm the part number on the original screen to ensure compatibility.
Measured against everything we stock in Monitor Mounts & Display Accessories, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Model name | 15.6LCD |
The single CCFL bulb draws modest power and runs warmer than LED panels, so expect noticeable heat at the bottom edge after several hours.
Your laptop must use a 30-pin CCFL video cable and inverter; the connector on the motherboard and the cable pin-out must both be 30-pin CCFL.
Yes, if the original panel is listed among the compatible part numbers such as LTN156AT01 or LP156WH1-TLA1, the mounting brackets and cable reach will align.
More in Monitor Mounts & Display Accessories
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?