We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Eagle Tool US 3/8 inch cable installer bit, 36 inch powder coated steel shaft with three flat shank

Eagle Tool Us

Eagle Tool Us EC37536 Cable Installer Bit 3/8 in 36 in pneumatic accessory

SKU CH-XX72-TS553

A 36-inch cable installer drill bit with a 3/8-inch split-point tip and 3/16-inch hex shank for deep drilling

  • Split-point tip starts holes cleanly without wandering
  • 36 in overall length reaches through studs and joists
  • 3/8 in drill size suits common cable diameters
  • 3/16 in hex shank locks securely in drill chucks
  • Powder-coated carbon steel resists corrosion during use

Eagle Tool US EC37536 Cable Installer Bit

This 36-inch cable installer bit is designed for routing wires through framed walls and ceilings. The split-point tip starts cleanly in wood without wandering. A 3/16-inch hex shank with three flats locks securely in drill chucks.

Electricians and low-voltage installers pulling

The 36-inch overall length suits standard wall cavities but will not reach through double-stud assemblies or deep floor trusses. Users needing shorter bits for tight boxes or longer bits for commercial chases should look elsewhere.

36-inch overall length

The bit drills to its full 36-inch length in a single pass, so the cavity depth must match. The 3/16-inch shank diameter limits torque transmission compared with larger-shank auger bits.

How it compares

Measured against everything we stock in Bits, Hole Saws & Accessory Kits, at today’s prices. Recalculated every night.

Price $21.99
Cheaper than about 60% of the 5,493 comparable items (median $27.99).

Specifications

Product
Brand nameEAGLE TOOL US

Questions about this item

How do I install the 3/8 in cable installer bit into my drill chuck?

Insert the 3/16 in hex shank fully into the chuck and tighten securely on the three flats; the split-point tip self-centres so you do not need a pilot hole.

What maintenance or replacement will this bit need over time?

The carbon-steel cutting edges will dull after repeated use in wood or plaster; resharpen or replace the bit when the split point no longer starts cleanly.

What limit appears first during a long cable run with the 36 in bit?

The maximum drilling depth is 36 in, so a single pass cannot exceed the overall length of the bit itself.

More in Bits, Hole Saws & Accessory Kits

Similar items