We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Eagle Tool US cable installer bit, 36 inch powder coated steel with three flat shank

Eagle Tool Us

Eagle Tool Us ESP37536 Cable Installer Bit 3/8in 36in pneumatic accessory

SKU CH-9Y36-88BBA

Drills 34 in deep with a 36 in serrated screw-point bit for cable pulling

  • Serrated screw point pulls cable through cleanly
  • 36 in overall length reaches deep cavities
  • 34 in max drilling depth covers long runs
  • 3/16 in hex shank locks securely in chuck
  • Powder coating resists wear on job sites

Cable Installer Bit 3/8in

The Eagle Tool US ESP37536 is a serrated screw-point drill bit designed for pulling cable through wood framing. Its 36-inch overall length and 34-inch maximum drilling depth suit electricians and low-voltage installers running wire between floors or through stud bays. The 3/16-inch hex shank with three flats locks securely in a standard drill chuck.

Powder-Coated Carbon Steel

Carbon steel construction with a powder-coated finish resists corrosion during everyday job-site exposure. The straight-flute geometry clears chips efficiently while the serrated tip grabs the wood to start the hole without walking. Normal drilling pressure produces typical rotary-tool noise and vibration; no unusual thermal load is generated by the accessory itself.

Replaces Shorter Auger Bits

This bit upgrades from standard-length auger or spade bits when the drilling depth exceeds their reach, such as traversing double top plates or deep header beams. It is not for masonry, metal studs or holes larger than 3/8 inch; installers needing wider pathways or concrete penetration should select a different tool.

How it compares

Measured against everything we stock in Bits, Hole Saws & Accessory Kits, at today’s prices. Recalculated every night.

Price $26.99
Typical for this category: the median of 5,493 items is $27.99.

Specifications

Product
Brand nameEAGLE TOOL US

Questions about this item

How do I fit the 3/16 in hex shank into my drill chuck without it slipping?

Tighten the chuck fully on the three flats of the 3/16 in hex shank; the flats stop the bit from spinning inside the jaws.

Will the powder coating wear off and need re-coating?

The powder coat protects the carbon steel from rust; if it chips, wipe the spot clean and apply a light oil film instead of re-coating.

What stops me from drilling deeper than 34 in with this 36 in bit?

The fluted section ends at 34 in, so chips cannot clear beyond that depth and the bit will bind if you push further.

More in Bits, Hole Saws & Accessory Kits

Similar items