Elemental LED DI-0906 60W 12V Constant Voltage Driver
A 12V 60W Class 2 constant-voltage LED driver for hard-wired low-voltage lighting systems
- Product typeBallasts
- 12V DC constant voltage driver for low-voltage LED systems
- Class 2 rated 60W output for safe operation
- Compatible with 120V switches and low voltage dimmers
- Works with RGB and DMX control systems
- Hard-wired power supply in multiple form factors
Product identity
This Elemental LED DI-0906 is a 60W 12V constant voltage driver built for low-voltage LED installations. It suits electricians and installers who need a Class 2 power supply that pairs with 120V switches, low voltage dimmers and RGB or DMX controls.
Thermals noise and power
The unit delivers a steady 12V DC output at up to 60W for compatible LED loads. As a constant voltage driver it regulates voltage rather than current, so thermal behaviour follows the attached lighting load and the enclosure in which it is mounted.
Deciding specification
The single figure that determines fit is the 60W rating at 12V; the connected LED system must not exceed this power level. Buyers who need more output capacity or a different output voltage cannot use this driver.
How it compares
Measured against everything we stock in Lamp Ballasts & Drivers, at today’s prices. Recalculated every night.
- Price $64.99
- Typical for this category: the median of 265 items is $61.99.
Specifications
| Product | |
|---|---|
| Brand name | DIODE LED |
| Product type | Ballasts |
Questions about this item
How do I hard-wire the 120V input to the 12V DC driver?
Connect the 120V supply wires to the driver's input terminals and the 12V LED load to the output terminals, ensuring correct polarity on the low-voltage side.
Will the driver need any maintenance or replacement parts over time?
No user-serviceable parts are inside; the sealed unit is replaced entirely if it fails after extended operation.
What is the maximum load I can run continuously on this 60W unit?
The Class 2 rating limits sustained output to 60W at 12V, so the connected LED load must not exceed that total wattage.
More in Lamp Ballasts & Drivers
