APC APCRBC158 UPS Replacement Battery for BX1000M
- Battery
- APCRBC158, APC
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A sealed lead-acid replacement battery pack for UPS units, hot-swappable for plug-and-play installation
This ENVEL battery pack is a direct replacement for APC RBC43 units used in uninterruptible power supplies. It arrives new and fully rechargeable with sealed lead‑acid cells inside a single pack. The plug‑and‑play design allows hot‑swap installation without powering down connected equipment. It restores runtime for servers, network gear and workstations that rely on APC UPS hardware.
Swap this unit in when the original RBC43 battery reaches end of life or shows reduced hold‑up time. The jump is worth it when runtime has dropped below acceptable levels or the UPS signals a battery fault. No firmware updates or configuration changes are required because the pack matches the original form factor and connector layout. One pack replaces the complete battery module in compatible UPS models.
This pack suits administrators maintaining APC UPS units that specify the RBC43 battery cartridge. It is not for buyers whose UPS requires a different RBC part number or a higher capacity module. It also does not fit UPS brands that use proprietary battery trays or non‑standard connectors. Verify the exact RBC designation on your UPS before ordering.
Measured against everything we stock in UPS Replacement Batteries, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Power | |
|---|---|
| Battery type | Replacement |
The RBC43 is a direct replacement cartridge designed to slide into the standard battery compartment of compatible APC UPS units without adapters or cable modifications.
Keep the UPS powered on, remove the front cover, disconnect the old cartridge, insert the new RBC43 pack, reconnect the plug firmly, then replace the cover — the UPS never transfers to battery during the swap.
Sealed lead-acid cells typically last three to five years; schedule replacement when the UPS reports a battery fault or runtime drops noticeably below the original rating.
More in UPS Replacement Batteries
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?