Estry DJ-296 Ni-MH 9.6V 700mAh standard battery

Replacement for Alinco handheld radios

This Estry Ni-MH pack delivers 9.6 V and 700 mAh to restore run-time on compatible Alinco transceivers. It replaces original part numbers EBP-48, EBP-48N, EBP-50N, EBP-51 and EBP-51N across a wide model range. The cell is built to the same electrical and mechanical specification as the factory unit. Safety circuits guard against over-charge, over-discharge, over-voltage and short-circuit events.

Steady output during long transmit cycles

Nickel-metal-hydride chemistry maintains a stable voltage plateau through extended push-to-talk sessions rather than sagging after a short burst. The 6.72 Wh capacity supports repeated transmissions across a shift without the rapid capacity fade seen in aged original packs. Protection electronics prevent damage if the radio is left keyed or stored in a discharged state. ISO 9001, RoHS, CE, UN 38.3 and MSDS certifications confirm consistent manufacturing quality.

Direct swap for depleted original packs

Users with a dead or weakened factory battery in any listed Alinco model can install this unit without modification. The physical footprint of 84.0 × 67.0 × 35.0 mm and 210.0 g mass matches the OEM pack so belt clips and battery compartments close normally. It is not suited for radios that require a higher voltage chemistry or a different connector polarisation. Buyers needing a larger capacity cell or a lithium-based alternative should verify their radio’s voltage tolerance first.