ETEIZU Magnetic Charger 2 Pin 4mm Pitch Accessory

Universal magnetic charger for wearables

This magnetic charging cable fits smartwatches, fitness trackers, bone conduction headphones and smart glasses that use a two-pin connector with a 4mm pitch. The contacts accept a tolerance of 3.8mm to 4.2mm centre-to-centre so buyers must verify the spacing on their device before ordering. A pure copper probe provides instant magnetic alignment and a secure hold that resists accidental detachment during charging.

Replaces lost or damaged proprietary cables

The accessory serves as a direct replacement when the original manufacturer charger is missing, frayed or no longer seats properly. Upgrading is worth it if the old cable suffers from intermittent contact or slow conduction because the pure copper probe and rapid conduction technology deliver a full charge in approximately 2 hours. It is not for devices that use a different pin count, a proprietary clip mechanism or inductive coils instead of exposed contacts.

Stable output under daily cycling

Built-in over-voltage and over-current safeguards maintain steady power delivery throughout the charging cycle rather than only at the start. The ABS housing and flexible PVC cable have been bent more than 5000 times in testing, so the connector retains its magnetic grip and electrical continuity after repeated connect and disconnect events. Heat buildup stays low during the full session, protecting both the charger and the wearable battery.