We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small 5015 turbo blower fan with three wires

Fans

Fans 5015 5 V .35 A 3 wire dual ball bearing turbo fan blower

SKU CH-RYE5-51JBQ

A 5 V, 0.35 A dual ball-bearing blower fan with three-wire control

  • Compact 5 V operation fits tight builds
  • Low 0.35 A draw reduces power load
  • Dual ball bearings extend service life
  • 3-wire connection enables speed monitoring

5 V 5015 blower for tight builds

This 5 V blower fits 5015 footprints and draws .35 A from a three-wire header. Dual ball bearings keep the rotor stable in continuous operation. It targets small-form-factor cases and custom cooling loops where axial fans cannot reach. Builders needing PWM speed curves or higher static pressure should look elsewhere.

Capacity and headroom

At 5 V the fan moves a modest air volume suited to VRM heatsinks, M.2 shields or single-slot GPU coolers. It runs out of headroom when faced with dense radiator fins or multi-GPU thermal loads. The three-wire connection reports speed but does not allow duty-cycle control below the motor’s start voltage.

How it compares

Measured against everything we stock in PC Cooling Fans, at today’s prices. Recalculated every night.

Price $13.99
Cheaper than about 70% of the 8,339 comparable items (median $19.99).

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Specifications

No published specifications for this item yet.

Questions about this item

Will the 5 V .35 A 3-wire connector fit the same header I use for my older 5015-size fans?

Yes, the 5 V .35 A rating and three-wire lead match the standard header used by 5015-format fans, so it plugs straight into the same motherboard or controller connector.

How can I confirm the dual ball bearing turbo blower is spinning correctly once installed?

Power the system and watch the fan RPM reported in BIOS or monitoring software; a steady reading that matches the 5 V .35 A spec means the blower is running as designed.

More in PC Cooling Fans

Similar items