We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small black rectangular projector cooling fan with wire leads

Fans

Fans SF51RH12-03A 12V .16A Projector Fan

SKU CH-ZK7J-7VQS7

DC 12 V 0.16 A replacement cooling fan for EMP-1705, 1710 and 1715 projectors

  • Direct replacement for EMP-1705, 1710, 1715 projectors
  • 12 V DC operation matches original power requirements
  • Low 0.16 A draw reduces electrical load
  • 51 mm frame fits designated mounting points

Replacement Fan for EMP Projectors

The SF51RH12-03A is a DC 12V 0.16A case fan built as a direct replacement for the original cooling unit in EMP-1705, EMP-1710 and EMP-1715 projectors. It restores factory airflow to keep the lamp and optics within safe operating temperatures.

Upgrade From a Failed or Noisy Unit

Install this fan when the original has stopped spinning, developed bearing noise or no longer moves enough air to prevent thermal shutdown. The jump is worth it if the projector runs hot, shuts down unexpectedly or the old fan rattles on startup.

How it compares

Measured against everything we stock in PC Cooling Fans, at today’s prices. Recalculated every night.

Price $28.99
Pricier than about 72% of the 8,339 comparable items (median $19.99).

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Specifications

No published specifications for this item yet.

Questions about this item

What mounting holes or bracket spacing does the SF51RH12-03A need to fit my EMP-1705 projector?

The SF51RH12-03A is built as a direct replacement for the original fan in the EMP-1705, 1710 and 1715 models, so it uses the same mounting pattern as the factory unit.

How do I install this fan and which step do people usually miss?

Disconnect power, remove the old fan, connect the 12 V 0.16 A leads matching polarity, secure the fan with the original screws, then verify the rotor spins freely before closing the case.

More in PC Cooling Fans

Similar items