greenDracaena D-90-Rotary 90° G1/4" Rotary Fitting 2-pack White

greenDracaena D-90-Rotary 90° Fitting Pair

This two-pack supplies nickel-plated brass 90° rotary adapters with G1/4" BSP threads for custom water-cooling loops. The male end offers a 5 mm thread length while the female end provides 6 mm, letting builders route tubing around tight corners without stress on rigid or flexible runs. Each fitting measures 1.29 in by 1.29 in by .59 in with a 17.9 mm knurled diameter and 28.9 mm installed height.

Upgrade from fixed 90° elbows

Fixed elbows lock orientation at install time, forcing tube bends to match the fitting. These rotary joints spin freely after tightening, so the outlet can be aligned precisely once the loop is pressure-tested. The jump is worth it when tubing paths cross motherboard heatsinks, GPU backplates or reservoir ports that leave no room for trial-and-error positioning. Builders using only straight fittings or non-rotary elbows gain the ability to finalise angles after the loop is filled.

Verify G1/4" thread compatibility and clearance

Confirm every component in the loop uses G1/4" BSP threads; mismatched thread standards will leak. Measure the space around each connection point — 28.9 mm installed height plus tube bend radius must fit between components and case panels. The 17.9 mm knurled diameter needs enough room for a wrench or fingers during assembly. Nickel-plated brass resists corrosion but should not contact bare aluminium blocks without a corrosion inhibitor in the coolant.