Grote G4603 Clearance Marker Lamp Rectangular Amber
Rectangular amber LED clearance marker lamp with bracket mount, 12 LEDs and FMVSS 108 compliance
- LED clearance lamp meets FMVSS 108 and SAE P2 standards
- Amber acrylic lens on polycarbonate housing resists impact and weather
- Bracket mount with blunt-cut wires enables permanent installation
- Twelve LEDs draw only 0.15 A for efficient operation
- Manufacturer backs the lamp with a two-year warranty
Grote G4603 Rectangular Clearance Lamp
The Grote G4603 is a rectangular clearance marker lamp designed for vehicle visibility compliance. It uses LED lighting technology with an amber polycarbonate lens and houses twelve individual LEDs. The unit mounts via a bracket for permanent installation on trucks, trailers or heavy equipment.
Upgrade from Incandescent Marker Lights
This lamp replaces older incandescent clearance lights that draw more current and require frequent bulb changes. The LED array operates at 0.15 A, reducing electrical load on the vehicle system. The jump is worth it when a fleet needs longer service intervals and consistent light output over thousands of operating hours.
FMVSS 108 Compliant Light Output
The lamp meets FMVSS 108 standards and carries SAE lens code P2 for front and side clearance marking. Its acrylic lens and polycarbonate housing resist vibration and weather exposure in commercial duty cycles. It is not suited for applications requiring red rear marker lenses or dual-intensity stop and tail functions.
How it compares
Measured against everything we stock in Workshop Hardware, Springs & Clamps, at today’s prices. Recalculated every night.
- Price $7.99
- Cheaper than about 92% of the 383 comparable items (median $17.99).
Specifications
| Product | |
|---|---|
| Brand name | GROTE |
Questions about this item
Will the 4 in width fit my existing bracket holes?
The lamp is 4 in wide and 2 in high with a bracket mount; measure your hole pattern against those dimensions before ordering.
How do I connect the blunt cut wires without a plug?
Strip each wire, crimp or solder to your harness, then seal with heat-shrink; the common mistake is leaving bare conductors exposed to moisture.
When should I expect to replace the 12 LEDs?
The polycarbonate housing and acrylic lens are sealed; if moisture enters or output drops below legal levels, replace the entire unit.
More in Workshop Hardware, Springs & Clamps
Similar items
De-Sta-Co 5105-R Vertical Hold-Down Clamp 700 lb Machine Shop Hardware
Medline SP 9671 Extension Spring 12 Pack 0.072 GA 9/16 In. x 6 In
- 9/16 in x6 in
- Steel
Renewable Lubricants Parts Cleaner Degreaser 5 gal Pail 86634 machine shop hardware
- HAWA





