Seagate BarraCuda ST8000DM004 8TB 5400 RPM 256MB SATA 3.5" internal hard drive
- 8 TB
- SATA 6.0Gb/s
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A 6 TB 3.5 inch 7200 RPM SAS internal hard drive for HP 3PAR StoreServ M6720 storage arrays
The HP 3PAR StoreServ M6720 is a 6 TB internal hard drive built for nearline storage in enterprise arrays. It uses a 6 Gb/s SAS interface and spins at 7200 RPM to serve bulk capacity workloads. The 3.5-inch form factor fits standard large-form-factor drive bays in compatible HP 3PAR StoreServ systems.
Six terabytes provide substantial space for archive, backup and secondary application data where access speed is less critical than cost per gigabyte. The 7200 RPM spindle delivers consistent sequential throughput for large-file workloads but will not match the random IOPS of flash-based tiers. Workloads demanding sub-millisecond latency or sustained high random writes will exhaust the mechanical limits of this drive.
The drive requires a 6 Gb/s SAS backplane and a carrier or bay that accepts 3.5-inch LFF devices measuring 1.5 inches wide by 6.5 inches high by 19.5 inches deep. It draws power and signal through the standard SAS connector without extra cabling. Installing this unit adds approximately 11.60 lb to the enclosure, so the chassis and rack rails must support the additional weight.
Measured against everything we stock in 3.5-Inch Internal Desktop HDDs, at today’s prices. Recalculated every night.
New to this? Paying with USDT: TRC-20 or ERC-20 — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | HP |
| Total capacity | 6 TB |
| Performance | |
| Rotational speed | 7,200 RPM |
The drive uses a 6Gb/s SAS interface and is backward compatible with 3Gb/s SAS controllers, though it will run at the lower link speed.
Check the drive's reported spindle speed in your storage array's management console or SMART data; it should show 7200 RPM.
The drive is supplied as a bare 3.5-inch mechanism only; any carrier tray or SAS cables required by your enclosure must be sourced separately.
More in 3.5-Inch Internal Desktop HDDs
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?