JacobsParts Inc. LTCH-B6-BLU 25mm Latching Push Button Disconnect Stainless Steel Blue LED IP67 250V 5A
A 25mm stainless steel latching push button with blue LED, IP67 waterproof rating and 250V 5A switching for automotive and marine panels
- Amperage5 A
- Rated voltage250 V
- Product typePushbutton
- Main materialMetal
- Key featuresWaterproof
- Latching action stays on until pressed again
- IP67 rating resists heavy rain and splashes
- Stainless steel body prevents corrosion
- Blue LED wires for constant or switched illumination
- Rated 250V 5A for AC or DC circuits
Product purpose and typical users
The JacobsParts LTCH-B6-BLU is a 25mm latching pushbutton switch rated for 250V and 5A. It suits automotive, marine and electronics projects that need a maintained on/off control for auxiliary lighting or power circuits.
Build quality and mounting details
The switch body is stainless steel with an IP67 protection rating against water and dust ingress. Installation requires a 25mm panel cutout and 20mm thread depth; a metal securing nut and rubber O-ring are included for sealing.
Thermals noise and power draw
The LED indicator draws 15mA at 12V DC and can be wired independently of the switch contacts. The mechanical contacts carry up to 5A at 250V AC/DC within an operating range of -20°C to 55°C with no active cooling required.
How it compares
Measured against everything we stock in Push-Button & Disconnect Switches, at today’s prices. Recalculated every night.
- Price $6.99
- Cheaper than about 80% of the 194 comparable items (median $19.49).
Specifications
| Product | |
|---|---|
| Brand name | JacobsParts |
| Model name | LTCH-B6-BLU |
| Product type | Pushbutton |
| Power | |
| Amperage | 5 A |
| Rated voltage | 250 V |
| Size & build | |
| Main material | Metal |
Questions about this item
What does the 250 V AC/DC 5 A rating cap in practice?
The switch is rated for a maximum of 250 volts AC or DC at 5 amps; do not exceed either value or the contacts may overheat.
What panel cut-out and depth does the 25 mm stainless body need?
Drill a 25 mm (1 inch) hole; the threaded neck is 20 mm deep and the full assembly including contacts extends 43 mm behind the panel.
How do I wire the blue LED so it lights only when the switch is ON?
Connect the LED anode to the normally open contact and the cathode to the load side; the LED then receives 12 V DC only when the latching circuit closes.
More in Push-Button & Disconnect Switches
Similar items
JacobsParts Inc. LTCH-O4-BLU Momentary Pushbutton Disconnect 19mm IP67 250V 5A Blue LED
- 5 A
- 250 V
Telemecanique Sensors XSAV12801 Ac/Dc Proximity Motion Detector
JacobsParts Inc. LTCH-Q3-BLU 16mm IP67 250V 3A Blue LED Latching Disconnect
- 3 A
- 250 V
JacobsParts Inc. LTCH-I4-BLU Momentary Pushbutton Disconnect 19mm IP67 250V 5A Blue LED 12V
- 5 A
- 250 V





